CBC ZN-MDI2 M-IR Series Quick User Manual page 55

Quick User Guide
Warning before installation
-Power off the Network camera if it is found to be smoking or smells unusual.
-Keep the Network camera away from water. If the Network camera gets wet, power
off immediately.
-Do not place the Network camera near heat sources, such as a television or oven.
-Refer to your instruction manual for the operating temperature.
-Keep the Network camera away from direct sunlight.
-Do not place the Network camera in high humidity environments.
-Do not place the Network camera on unsteady surfaces.
-Do not touch the Network camera when there is lightning present.
-Do not disassemble the Network camera.
-Do not drop the Network camera.
-Do not insert any object into the Network camera, such as a screwdriver.
For other safety and regulation information, please refer to "User's manual".
1. Check Contents
No. Item
1 Network Camera
2 Software CD
3 Quick User Guide
4 Accessories
2. Physical Description
1. Network (RJ-45 PoE supported)
2. Audio In (Line in)
3. Audio Out (Line Out)
4. Alarm In / Out connector (Dry contact / Relay out [2A:AC120V/DC60V])
5. Power (DC12V / AC24V)
Description
ZN-DT Series (ZN-DT2MAP / ZN-DT1MAP / ZN-DT1A)
User's Manual, Utility software
This document
Bottom Cushion Plate
Both-sided Tape
Silica-Gel
Anchor : 4pcs
O-ring : 4pcs
Tapping Screw 4x30 : 4pcs
Hexalobular L-key Wrench
Alarm I/O extension cable
Video monitor cable
ZN-DT Series Network Camera
Alarm In / Out connector
Ver1.20 EN
1