CBC ZN-BxMTP Series Quick User Manual

Advertisement

Quick User Guide

Warning before installation

-Power off the Network camera if it is found to be smoking or smells unusual.
-Keep the Network camera away from water. If the Network camera gets wet,
power off immediately.
-Do not place the Network camera near heat sources, such as a television or
oven.
-Refer to your instruction manual for the operating temperature.
-Keep the Network camera away from direct sunlight.
-Do not place the Network camera in high humidity environments.
-Do not place the Network camera on unsteady surfaces.
-Do not touch the Network camera when there is lightning present.
-Do not disassemble the Network camera.
-Do not drop the Network camera.
-Do not insert any object into the Network camera, such as a screwdriver.
For other safety and regulation information, please refer to "User's manual".

1. Check Contents

No. Item
1
Network Camera
2
Software CD
3
Quick User Guide
4
Accessories
Description
ZN-BxMTP Series
User's Manual, Utility software
This document
Template for installation
Anchor : 4pcs
Tapping Screw 4x30 : 4pcs
O-ring : 4pcs
Hexalobular L-key Wrench
Wrench bolt 3pcs
Video monitor cable
Power Jack Cable
Terminal Block (2pin/8pin)
ZN-BxMTP Series Network Camera
1
Ver1.20 EN

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ZN-BxMTP Series and is the answer not in the manual?

Questions and answers

Summary of Contents for CBC ZN-BxMTP Series

  • Page 1 Quick User Guide ZN-BxMTP Series Network Camera Warning before installation -Power off the Network camera if it is found to be smoking or smells unusual. -Keep the Network camera away from water. If the Network camera gets wet, power off immediately.
  • Page 2: Physical Description

    Quick User Guide ZN-BxMTP Series Network Camera 2. Physical Description 1. Network (RJ-45 PoE supported) 2. Power connector (24VAC: Heater) 3. I/O signal terminal Audio In (Line in) Audio Out (Line Out) Alarm In (Dry Contact) Alarm Out (Relay out [0.5A:125VAC / 1A:30VDC]) 4.
  • Page 3 Quick User Guide ZN-BxMTP Series Network Camera 4. Assign IP address The default setting of the camera is set to “DHCP” and “UPnP” function is set to ON. If you have a DHCP server on your network and UPnP function is enabled on your PC you can find the network camera in “My network”.
  • Page 4 Quick User Guide ZN-BxMTP Series Network Camera 5. Web browser connection Note : The Network camera supports Internet Explorer 7 or above. Please check version of your browser and update it if necessary. When you first access the camera you need to download and install an Active X control from the camera to display a Live image.

Table of Contents