Table of Contents
Advertisement
Secondary Master/Slave UDMA
Ultra DMA/33 implementation is possible only if your IDE hard drive supports it and the
operating environment includes a DMA driver (Windows 95 OSR2 or a third-party IDE bus
master driver). If your hard drive and your system software both support Ultra DMA133,
select Auto to enable BIOS support. The settings are: Auto, Disabled.
IDE DMA Transfer Access
The integrated peripheral controller contains an IDE interface with support for one IDE
channels. Select Enabled to activate each channel separately. The settings are: Enabled and
Disabled.
IDE HDD Block Mode
Block mode is also called block transfer, multiple commands, or multiple sector read/write.
If your IDE hard drive supports block mode (most new drives do), select Enabled for
automatic detection of the optimal number of block read/writes per sector the drive can
support. The settings are: Enabled, Disabled.
SATA Function
This item allows you to control Serial ATA controller by setting it as Enabled or Disabled.
SATA/RAID Mold
The optional settings are IDE; RAID.
3-7-2 Onboard Device Function
Onboard HD Audio Device
Realtek Lan1 Device
Realtek Lan1 Bootrom
↑↓→← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values
Onboard HD Audio Device
This item allows you to decide to enable/disable the chipset family to support HD Audio.
The settings are: Enabled, Disabled.
Phoenix – AwardBIOS CMOS Setup Utility
Onboard Device Function
F6:Optimized Defaults
Auto
Enabled
Menu Level >>
Disabled
F7:Standard Defaults
27
Item Help
Advertisement
Table of Contents
