Table of Contents
Advertisement
3-8
Power Management Setup
The Power Management Setup allows you to configure your system to most effectively save
energy saving while operating in a manner consistent with your own style of computer use.
ACPI function
Assign IRQ For ACPI
Video off option
Video off Method
MODEN USE IRQ
Power Button Function
Power Sts after power failure
HPET Support
WDRT Support
WDRT Run/stop
WDRT Count
Wake UP Events
↑↓→←
Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General H
F5:Previous Values
ACPI Function
The optional settings are S1(POS) and S3(STR).
Video Off Method
This determines the manner in which the monitor is blanked.
DPMS (default) Initial display power management signaling.
This option only writes blanks to the video buffer.
Blank Screen
V/H SYNC+Blank
horizontal synchronization ports and write blanks to the video buffer.
MODEM Use IRQ
If you want an incoming call on a modem to automatically resume the system from a
power-saving mode, use this item to specify the interrupt request line (IRQ) that is used by
the modem. You might have to connect the fax/modem to the motherboard Wake On Modem
connector for this feature to work.
Power Button Function
Under ACPI (Advanced Configuration and Power management Interface) you can create a
software power down. In a software power down, the system can be resumed by Wake up
Phoenix – AwardBIOS CMOS Setup Utility
Power Management Setup
S1(POS)
IRQ 9
Suspend-off
V/H
3
Instant off
Always O
Enabled
Disab
Stop
1023
Press Enter
F6:Optimized Defaults
This selection will cause the system to turn off the vertical and
SYC+Blank
FF
led
F7:Standard Defaults
31
Item Help
Menu Level >
elp
Advertisement
Table of Contents
