Table of Contents
Advertisement
Alarms. This item lets you install a software power down that is controlled by the power
Button on your system. If the item is set to Instant-Off, then the power button causes a
software power down. If the item is set to Delay 4 Sec, then you have to hold the power
button down for four seconds to cause a software power down.
Wake Up Events
Users can press Enter to select the relative items for wake up events. Set it as Disabled or
Enabled in Wake-Up on LAN, Wake-Up on Ring and Wake-Up on PCI card. Users can also
enter password in PS2KB Wakeup.
Wake-Up on RTC Alarm
When set to Enabled, additional fields become available and you can set the date (day of the
month), hour, minute and second to turn on your system. When set to 0 (zero) for the day of
the month, the alarm will power on your system every day at the specified time .
Date (of month)
You can choose which month the system will boot up. Set to 0, to boot every day.
Time (hh:mm:ss)
You can choose what hour, minute and second the system will boot up.
Note: If you have change the setting, you must let the system boot up until it goes to the
operating system, before this function will work.
3-9 PnP/PCI Configuration
IRQ Resources
PCI/VGA Palette Snoop
Assign IRQ For VGA
Assign IRQ For USB
↑↓→← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values
PCI/VGA Palette Snoop
This item is designed to overcome problems that can be caused by some non-standard VGA
cards. This board includes a built-in VGA system that does not require palette snooping so
you must leave this item disabled.
Phoenix – AwardBIOS CMOS Setup Utility
Pnp/PCI Configuration
F6:Optimized Defaults
Press Enter
Disabled
Enabled
Menu Level >
Enabled
F7:Standard Defaults
32
Item Help
Advertisement
Table of Contents
