Panel Testing; Wf-Motor Current Measuring; Layout - Kemppi KEMPACT PULSE 3000 Service Manual

Panel testing

Panel switches, LEDs and displays can be tested. After turning the power source on (3 sec.) all LEDs
and displays should be lighted and after pressing any of the buttons the program versions should be
shown on the panel.
Wire feed motor current measuring
By pressing the Wire Inch-button and plate thickness-button simultaneously the motor M001
current will be seen on the right side of the display.
Panel layout
Panel program version
Power source program version
Wire feed motor current
X10 X11 X1
X1
Flat cable panel >
power source
X10 Programming
connector, panel
X11 Programming
connector, power
source
21