Trouble Shooting - Progressive Turf Equipment TDR-X Operator's Manual & Parts List

TROUBLE SHOOTING

PROBLEM
Belt slippage
Rapid belt wear
Belt squeal
Over-heated bearings
Mower Deck will not lower.
Vibration on turning
Damage to intermediate
bearing or tractor PTO
shaft
Premature spindle bearing
failure
CAUSE
Lack of tension
Oily drive conditions
Over Loading
Belt slippage
Belt not aligned properly
Belt slippage
Belt slippage
Insufficient Cooling
Orifice in cylinder plugged
Drawbar length incorrect.
Input shaft does not collapse
easily under power
Water ingestion from washing
Improper rebuild procedure
Improper bearings
TDR-X Operator's Manual
REMEDY
Inspect & check tension adjustment
as required
Clean drive
Increase cutting height or reduce
ground speed
See Above
Check pulley alignment and proper
spacers
See Above
See Above
Remove deck shields and clean out
all grass.
Remove orifice and
obstruction and reassemble
Adjust drawbar to specification
Remove input shaft, pull apart and
deburr / grease splines
Grease at proper interval.
Rebuild spindle with OEM repair kit
DO NOT wash down mower when
spindle housings are warm
See specific instructions in manual
Use only OEM bearings
remove
45