Progressive Turf Equipment TDR-X Operator's Manual & Parts List page 41

TDR-X Operator's Manual
FIXED BLADE REMOVAL AND INSTALLATION
A 1" diameter pilot centers the blade of the Pro-EZII blade holder on the
spindle with two 1/2" grade 5 fasteners. When changing blades, be sure that
pilot is properly seated in the blade and the blade lies flat on the spindle bar.
Eroded
Area
Always replace bolts, lock washers and nuts when replacing blades. Tighten
bolts to proper torque as listed on Page 37.
Replace any blade that is bent, nicked deeper than ¼", excessively worn or
has any other damage. Small nicks can be ground out during sharpening.
Always balance blades before use.
Deep
In abrasive soil conditions, monitor condition of the blade wing. If erosion of
Nick
the steel is evident at the base of the wing, replace blade.
PRO-EZII BLADE REMOVAL AND INSTALLATION
Pro-EZII Blade Bar
A 1" diameter pilot centers the blade bar on the spindle with two 1/2" grade
Blade
Nut
5 fasteners. When changing blades, be sure that pilot is properly seated in
Bar
the blade bar and the blade bar lies flat on the spindle.
Always replace bolts, lock washers and nuts when replacing blade bars. Lock
Tighten bolts to proper torque as listed on Page 37. Washer
Replace any blade bar that is bent, worn or has any other damage.
Blade
Tip
Blade Bolt
39