Trouble Shooting - Progressive Turf Equipment TD92 Operator's Manual

TROUBLE SHOOTING

PROBLEM CAUSE
Incorrect tire pressure
Uneven Cutting Improper Hitch Set-up
Improper Height Setting
Lack of tension
Belt slippage /
Squeal
Over Loading
Belt slippage
Rapid belt wear Belt not aligned properly
Over heating
Belt slippage
Over-heated
bearings
Insufficient Cooling
Over-heating
Improper rebuild procedure
Premature spindle
Improper bearings
bearing failure
Water Ingress
Deck safety locks Wing not raising fully to
will not engage release lock
Mower Deck will not
Orifice in cylinder plugged
lower.
Vibration on turning Drawbar length incorrect.
Damaged
Input shaft does not collapse
intermediate bearing
easily under power
or tractor PTO shaft
REMEDY
Check that all deck tires and transport tires are set at
correct pressure
Check that mower hitch is installed such that mower
frame is level to ground (see Page 19)
Ensure that the same number of spacers are present
on the deck tires and corner pins.
Inspect & adjust tension as required
Increase cutting height or reduce ground speed
See Above
Check belt alignment. Ensure belts are running in
proper groove on pulley.
Ensure decks are free from clipping build-up
See Above
Ensure decks are free from clipping build-up
See Above
See specific instructions in manual
Use only OEM bearings
-Avoid direct spray on bearing during washing
-Ensure drain holes on decks are not clogged
Decrease center distance of cylinder with adjustable
clevis on cylinder rod.
Remove orifice and remove obstruction and
reassemble
Adjust drawbar to specification (see Page 19)
Remove input shaft, pull apart and deburr / grease
splines
Grease at proper interval.
TD92 Operator's Manual
43