Check Operation Of Lock System - Progressive Turf Equipment TDR-X Operator's Manual & Parts List

TDR-X Operator's Manual
INTERMEDIATE BEARING – 50h / Weekly (1 Location)
ROLLER-END BEARING 50H / Weekly (12 Locations)
TRANSPORT HUBS: 100h / Monthly
The transport wheel hubs have greaseable tapered roller bearings. They
should be inspected frequently and lubricated as required.

CHECK OPERATION OF LOCK SYSTEM

In a safe level location, fully lower the decks to the ground, shut the tractor
engine off, and set the parking brake.
1. With the lock rope released, all three lock arms should lay flat, resting
against the 3/8" bolts. This is critical for proper function of the Pro Lift-N-
Turn™ and wing lock system (For more information see page 29)
2. Have a helper pull and release the pull rope/lock release arm and verify
that lock release cams move freely. If they do not, disassemble, clean,
inspect and grease, replace bushings if necessary
3. Ensure that the lock arms move freely. If they do not move freely,
disassemble, clean, inspect and grease. Replace bushings if necessary.
4. Lock release springs (under main frame) should be replaced every 2
seasons to ensure trouble free operation of the lock system. Kit part
number 214022.
If any binding or damage is found, repair the issue before proceeding to use
the mower
34
Lock arm
Lock release cam