Hitching The Mower To The Tractor; Stowing The Jack; Connecting The Pto To The Tractor - Progressive Turf Equipment TDR-X Operator's Manual & Parts List

TDR-X Operator's Manual

HITCHING THE MOWER TO THE TRACTOR

Crushing Hazard between tractor and mower. Never allow anyone
to stand between tractor and mower while backing-up to the
mower
1) With the draw pin placed in the hitch clevis (Figure 3 page 19), back the
tractor to the hitch clevis.
2) When the draw pin holes are aligned, place the tractor controls in the
park position, shut the engine off and engage the parking brake.
3) Remove draw pin from the hitch clevis and place in the draw pin hole
connecting the mower to the tractor.
4) Note always use the provided hitch pin. The flat top design provides
additional clearance to the underside of the input PTO. Never use hitch
pins with D ring type handle.
5) Raise parking jack fully and place in storage position (Figure 4).

STOWING THE JACK

The jack cannot be stowed in the parked position while mowing. A second
storage position is provided on the Left-hand deck to avoid damage to the
jack while mowing (Figure 4).

CONNECTING THE PTO TO THE TRACTOR

1) Ensure that the tractor engine is shut off, the parking brake is engaged,
and the mower is securely hitched to the tractor.
2) Lift input PTO shaft from PTO support, ensuring that PTO support
swings down and rests on frame tube.
3) Slide the mower input shaft locking collar backwards, opening the
locking mechanism. Locking collar should remain in an open position
4) When it is safe to do so, hold the PTO against the end of the tractor PTO
shaft, rotate the PTO by hand until the shaft slides on slightly.
5) Slide the yoke onto the tractor's PTO.
6) The locking collar should automatically engage when the yoke is
properly engaged with the tractor PTO.
7) Attempt to move the shaft forward and backwards to ensure that it is
securely locked in place.
8) Attach the PTO cover safety chain to the tractor. Ensure cover is
properly retained by the chain on the mower end.
9) The TDR-X is equipped with a PTO support to aid in connecting the
mower to the tractor. Once the PTO shaft is connected to the tractor,
fold the PTO shaft support down onto the frame and secure it with the
supplied cotter pin before operating – DO NOT LEAVE SUPPORT IN
UPRIGHT POSITION. See Figure 2 page19
If the PTO shaft comes off during operation, it may cause
personal injury and damage to the PTO shaft and tractor PTO.
When checking, make sure the locking collar is locked, and that
the shaft is not just jammed against the end of the tractor PTO
shaft.
20
Figure 4