Decimal Shift - Raven Spra-Coupe SCS 460 Operator's Manual

11. DECIMAL SHIFT

The DECIMAL SHIFT feature is used to increase system accuracy at low application
rates. Shifting of the decimal point is done during the entry of METER CAL. After
entering METER CAL mode, depress the decimal shift
bration constant number, and depress
while in METER CAL is to enter the meter calibration constant number and depress
. The following table illustrates how shifting the decimal point can
increase system accuracy.
RATE DISPLAY
RATE 1 CAL
RATE 2 CAL
TANK VOLUME
TOTAL AREA
TOTAL VOLUME
FIELD AREA
FIELD VOLUME
VOL/MINUTE
AREA/HOUR
RATE +/-
LOW TANK LEVEL
LOW VOL/MIN
When entering RATE 1 CAL and RATE 2 CAL, remember that 2 GPA [20 lit/ha] is entered as
2.0 [20.0] when unshifted and 2.00 [20.00] when shifted.
DECIMAL PLACE LOCATIONS
US
UNSHIFT SHIFT
000.0 00.00
000.0 00.00
000.0 00.00
0000 000.0
000.0 000.0
0000 000.0
000.0 000.0
0000 000.0
0000 000.0
000.0 000.0
000.0 00.00
0000 000.0
0000 000.0
. The sequence to unshift the decimals
METRIC
UNSHIFT SHIFT
0000 000.0
0000 000.0
0000 000.0
0000 000.0
000.0 000.0
0000 000.0
000.0 000.0
0000 000.0
0000 000.0
000.0 000.0
0000 000.0
0000 000.0
0000 000.0
27
, enter the meter cali-
TURF
UNSHIFT SHIFT
00.00 00.00
00.00 00.00
00.00 00.00
000.0 000.0
0000 0000
000.0 000.0
0000 0000
000.0 000.0
000.0 000.0
0000 0000
00.00 00.00
000.0 000.0
000.0 000.0