Raven Spra-Coupe SCS 460 Operator's Manual page 19

6) Selecting C-SD, C-F, C-FC, C-P or C-PC.
a) To select C-Sd, C-F, C-FC, C-P, or C-PC, press
displayed.
b) Momentarily depress
CAL SELF TEST 00
7) Definition of Boom Calibration keys.
Depressing this key displays selected boom number in display.
EXAMPLE: Boom 1 will be displayed as
Depressing this key after selecting BOOM CAL changes the boom number.
EXAMPLE:
Depressing this key after selecting BOOM CAL changes the boom number.
EXAMPLE:
Enter Boom Data:
a) Select boom
b) Use boom width as calculated under "CALCULATING BOOM CAL".
c) If a boom is not needed, enter a "0" for the length.
8) Enter SPEED CAL calibration number in
9) Enter METER CAL calibration number in
10) Enter appropriate VALVE CAL calibration number (2123, 743, or 43 in
11) Enter the target RATE 1 (GPA) [lit/ha] {GPK} in
12) Enter the target RATE 2 (GPA) [lit/ha] {GPK} in
(If you do not use a second rate, enter the same rate as RATE 1 CAL).
NOTE: RATE 2 should not be more than 20% different from RATE 1 or else spray
pattern may suffer.
PROGRAMMING THE CONSOLE IS NOW COMPLETED.
The flashing "CAL" will now extinguish.
After the console is programmed, if there is a need to change initial console programming
(working units, speed sensor programs or valve drivers), hold
The display will flash the current program setting.
sired selection.
speed (SP1, SP2) and valve driver selections (C-SD, C-F, C-FC, C-P, C-PC).
.
CAL BOOM 1 CAL 0
CAL BOOM 2 CAL 0
1 CAL
.
Press to complete entry.
, the DATA display will now display
CAL BOOM 1 CAL
CAL BOOM 2 CAL 0
to
CAL BOOM 1 CAL 0
to
.
.
If not, repeat procedure starting at Step 7.
Press
Repeat procedure as necessary for
16
until desired code is
.
.
.
.
.
for 30 seconds.
to switch to the de-
.