Raven Spra-Coupe SCS 460 Operator's Manual page 27

11) DATA LOGGER TRIGGER UNITS
a) Display will show
b) Depressing
TRIGGER UNITS FEET [METER]
been programmed previously. (SEC means seconds has been chosed as the unit
of measure.)
c) Momentarily depress
12) DATA LOGGER ON/OFF
a) The DATA LOGGER uses the communications strings listed in Appendix 9 to
pass data out through the serial port.
interval or a set distance traveled, as determined by the values entered
in the DATA LOGGER TRIGGER VALUE and DATA LOGGER TRIGGER UNITS. Upon each
trigger, the Actual Rate string, Data Strings 1, 2, and 3, and the Time/
date string are sent, in that order. When a Console calibration value is
changed, the Console will automatically send out the Cal 1, 2, and 3
strings.
and Cal 1, 2, 3 strings will be sent by the Console. The Data, (with Time/
Date string included) and Cal strings can also be requested by the data
logger using the request strings shown in Appendix 9.
NOTE: Some options within the DATA MENU LISTINGS may be unavailable if certain
features are on or active.
CONSOLE DATA PRINTOUT: Console Data Printout will not be available when DATA
GPS OPTIONS:
DATA LOGGER:
b) Display will show
c) Depressing
ON
and
means DATA LOGGER is enabled.
d) Momentarily depress
13) PRESSURE CALIBRATION OF THE PRESSURE TRANSDUCER
Used to set the zero point of the pressure transducer for pressure display.
a) Display will show PRESS ENTER TO CAL PRESSURE.
b) Display will show ENTER SYSTEM PRESSURE.
c) Enter actual system pressure and press
d) Momentarily depress
DATA LOG TRIGGER UNITS
momentarily changes the display between
to advance to DATA LOGGER.
When a Console switch is changed, the Data 1, 2, 3, Time/Date,
LOGGER is ON or when GPS functions are active.
GPS options will not be available when DATA LOGGER is
ON.
DATA LOGGER will not be available when GPS functions are
active.
DATA LOG OFF
momentarily changes the display between
OFF
. A value of
SEC
and . DATA LOGGER TRIGGER VALUE has
The data is sent at a set time
The options affected are:
.
means DATA LOGGER is disabled; a value of
to advance to PRESSURE CALIBRATION.
to advance to OFF RATE PERCENT 30.
24
FEET [METER]
.
DATA LOG
DATA LOG OFF
Press .
.
ON