Tip-Over Hazards - Mec Crossover Series Operator's Manual

Crossover Series

Tip-over Hazards

DO NOT OVERLOAD
Art_2828
Art_2834
DO NOT DRIVE ON IRREGULAR OR
UNSTABLE SURFACE
Art_2833
DO NOT PUSH OR PULL OBJECTS
OUTSIDE PLATFORM
Art_2831
DO NOT ELEVATE IN WINDY
CONDITIONS
Art_2832
DO NOT USE AS CRANE
92555
Crossover Series
DO NOT exceed the maximum platform capacity. The weight of options and accessories will
reduce the rated platform capacity and must be factored into the total platform load. Refer to
the decals on the options.
DO NOT elevate the platform when the machine is on a surface that is soft and/or on a slope.
STOP if the alarm sounds and the red light illuminates when the platform is raised. Use
extreme caution to lower the platform.
Driving: DO NOT drive the machine on a slope that exceeds the maximum uphill or downhill
slope rating. Slope rating applies to machines in the stowed position.
Driving in stowed position: use extreme care and reduce speed when driving across uneven
terrain, debris, unstable or slippery surfaces, and near holes or drop-offs.
Driving with the platform elevated: DO NOT drive on or near uneven terrain, unstable
surfaces, curbs, drop-offs or other hazardous conditions.
DO NOT push off or pull toward any object outside the platform.
Maximum Allowable Side Force
ANSI and CSA
50 lbs (222 N) per person
DO NOT elevate the platform when wind speeds are in excess of 28 m.p.h. (12.5 m/s). If wind
speeds exceed 28 m.p.h. (12.5 m/s) when the platform is elevated, carefully lower the platform
and discontinue operation.
DO NOT increase the surface area of the platform (i.e. cover the rails with tarp or plywood).
Increased surface area exposed to the wind will decrease machine stability.
DO NOT attach overhanging loads or use the machine as a crane.
DO NOT exceed the Sheet Materials Rack maximum capacity of 250 lbs (113 kg).
Ensure material is secure.
NEVER transport tools and materials unless they are firmly secured. Secure all tools and loose
materials.
NEVER alter or disable any machine components.
NEVER replace any part of the machine with items of different weight or specification.
NEVER modify or alter the work platform without written permission from MEC.
NEVER place ladders or scaffolds in the platform or against any part of the machine.
NEVER use the machine on a moving or mobile surface or vehicle.
Ensure that all tires are in good condition and lug nuts are properly torqued.
Safety
Page 5
June 1, 2012