Deck Extension; Sheet Materials Rack - Mec Crossover Series Operator's Manual

Crossover Series

Deck Extension

IF THE ROLL-OUT DECK IS EXTENDED CHECK FOR CLEARANCE UNDER DECK AREA BEFORE LOWERING
PLATFORM.

Sheet Materials Rack

DO NOT exceed the Sheet Materials Rack capacity of 250 lbs (113 kg).
DO NOT allow any personnel to stand below the machine when the Sheet Materials is in use.
DO NOT use with optional 55" wide platform. DO NOT lift or attach material to the outside of the
optional 55" wide platform.
Fasten the material securely with straps until use.
ART_3846
92555
Crossover Series
Deck Extension
Handle
• Squeeze the handle at the rear of the extension deck to raise the spring-loaded pin
from the locked position.
• With handle raised, push the deck out to the desired extended length and release the
handles for the spring-loaded pin to lock into position.
• Extensions can be achieved in intervals of 6 inches (15 cm) throughout the entire
length of the roll-out extension deck.
This machine is equipped with a Sheet Materials Rack. Up to 250 lbs (113 kg) of
sheet material may be secured outside the platform to this rack. Maximum size
of material on the Sheet Material Rack is 4' x 8' (1.2m x 2.4 m) for outdoor wind
loading. All material should be centered on the Sheet Materials Rack.
Fasten the sheets to the platform with straps until ready to use. Attach the straps
to the guardrail of the main platform only. DO NOT fasten the straps to the deck
extension guardrail.
Use caution when driving the machine or elevating the platform when the Sheet
Material Rack is loaded.
Operating Instructions & Function Tests
Deck
Extension
ART_3843
Page 19
June 1, 2012