KEB COMBIVERT F5 Installation Manualline page 55

6 Warning or error message at abnormal stopping
7 Overload pre-warning
8 Overtemperature alert signal power stage
9 External Overtemperature alert signal motor
11 Overtemperature alert signal interior OHI
12 Cable breakage 4...20 mA on analog input 1
14 max. constant current (Stall, CP.25) exceeded
15 max. ramp current (LA-Stop, CP.24) exceeded
16 DC-braking active
20 Actual value = set value (CP.3 = Fcon; rcon; not at noP, LS, error, SSF)
21 Accelerate (CP.3=FAcc, rAcc, LAS)
22 Decelerate (CP.3 = FdEc, rdEc, LdS)
23 Real direction of rotation = set direction of rotation
24 Utilization (CP.6) > switching level
25 Active current > switching level
26 Intermediate circuit voltage (CP.7) > switching level
27 Real value (CP.1) > switching level
28 Set value (CP.2) > switching level
31 Absolute set value at AN1 > switching level
32 Absolute set value at AN2 > switching level
34 Set value at AN1 > switching level
35 Set value at AN2 > switching level
40 Hardware current limit activated
41 modulation on
44 Inverter status > switching level
45 Power stage temperature > switching level
46 Motor temperature > switching level
47 Ramp output value > switching level
48 Apparent current (CP.4) > switching level
49 Forward running (not at nOP, LS, abnormal stopping or error)
50 Reverse running (not at nOP, LS, abnormal stopping or error)
63 Absolut ANOUT1 > switching level
64 Absolut ANOUT2 > switching level
65 ANOUT1 > switching level
66 ANOUT2 > switching level
70 Driving current active (safety relay)
73 Absolute active power > switching level
74 Active power > switching level
No listed values are only for application mode.
CP.34 Source of rotation direction
The source rotation setting and the mode of evaluating the rotation setting is defined with
this parameter (Enter-Parameter). With CP.34 one does not modify the rotation source of
the fixed frequencies (CP.19...21).
Value Direction of rotation
0/1 only application mode
2 Setting by way of terminal strip forward/reverse; negative set values are set to
zero (factory setting).
GB - 27