Check The Air Intake Lines - Fayat Group Bomag BW 138 AD-5 Operating Instruction, Maintenance Instruction

Maintenance – Every 250 operating hours
Fig. 169
8.7.2.2 Tightening the V-belt
Fig. 170
8.7.3

Check the air intake lines

172
3. Check the entire circumference of the V-
belt for damage and cracks.
4. Replace a damaged or cracked V-belt
Ä Chapter 8.8.2 „Replacing the V-
belt" on page 178.
5. Check with thumb pressure whether the V-
belt can be depressed more than
7 to 9 mm (0.28 – 0.35 inch) between the
V-belt pulleys, retighten if necessary.
Protective equip-
ment:
1. Loosen the tensioning screw (1) and the
screw (2) on the generator.
2. Press the generator towards the outside
using a lever, until the correct V-belt ten-
sion is reached.
3. Retighten clamping screw (1) and screw
(2).
Protective equip-
ment:
1. Park the machine in secured condition
Ä Chapter 6.8 „Parking the machine in
secured condition" on page 121.
2. Allow the engine to cool down.
3. Check the condition and tight fit of all air
intake lines and hose clamps.
4. If fuel lines or hose clamps are found to be
damaged, the corresponding parts must be
immediately replaced.
BW 138 AD-5
n Working clothes
n Protective gloves
n Working clothes
n Protective gloves