Introduction; Main Characteristics - BFT CSB Xtreme Installation And User Manual

1. INTRODUCTION

The control unit has been developed to control automatic single-phase barriers with inverter-driven three-phase motor.
= Electrical connections confi gured at the factory.

2. MAIN CHARACTERISTICS

- Microprocessor logic
- LEDs displaying inputs/outputs status
- Integrated radio receiver 433.92MHz, 2 channels, 2 048 codes
- TCP/IP module and RS485 module (Option)
J3
F3
F4
K1
J4
F1
J2
K2
F2
J1
J5
J1: Control unit power supply
J2: Inverter power supply
J3: Transformer connector
J4: Flashing light output
J5: Outputs/accessories power supply
J6: Encoder/inputs
J7: Inputs/antenna
J8: Boom lights connector
J9: Inverter signals
OUT
J2 LAMP
230Vac
40W max
N L
230 Vac
INVERTER
J1
L N
230Vac
50-60Hz
Control unit
J8
DL
F
J9
K3 K4 K5
J6
J10:
J12:
DL:
START:
F1:
F2:
F3, F4:
F, - , + :
PR1, PR2: Radio receiver programming push buttons
J5
- 3-digit display for programming and system status
- Up to 4 confi gurable outputs
- Radio programmer connector
- Built-in heater for cold climates (Termon)
J10
J12
J11
PR2
PR1
J7
Expansion connector
Radio programmer connector
3-digit LED display
"START" control button
Transformer primary fuse: 500 mAT (230Vac) - 1 AT (115Vac) 5x20mm
Line fuse (control board and inverter): 4 AT (230Vac) - 8 AT (115Vac) 5x20 mm
Transformer secondaries fuses: 2 AT 5x20mm
Programming push buttons
J9
B A
RS 485 OUT
INVERTER
ENCODER
- 19 -
J6
EN
J7