Power Input; Product Installation - Event Lighting ORBIT2 User Manual

•
ORBIT2 must be installed at least 3 metres above ground level and at least 3 metres
horizontally from any person. See the Product Installation section for details.
•
Do not point the laser at any person or animal.
•
Do not point the laser towards any area where people could be exposed to it.
•
Do not point the laser towards any reflective surfaces, such as windows, mirrors and
metals. Laser reflections can also cause injury.
•
Do not point the laser towards any area where you or the operator do not know where it
is being directed.
•
Do not point the laser into the sky or towards any aircraft.
•
The legal requirements for operating laser products vary between jurisdictions. It is the
user's responsibility to meet the legal requirements in the location/country of use.
Additional laser warning stickers (pictured above) are included with this user manual. Please
attach these to the power supply.

Power Input

This device has an auto-switching power supply work with input voltage range of 100~240 VAC,
50/60 Hz.

Product Installation

•
This device can be mounted in many orientations provided each individual device is
secured by the use of correct mounting bracket.
•
This device should be directed above the heads of people. Do not direct this device
towards the line of sight of anyone.
o
Refer to the diagram below.
•
A minimum of 3 meters vertical separation is required between the floor and the laser
device.
•
A minimum of 3 metres horizontal separation is required between the laser light and any
person or public space.
•
Use a safety chain when mounting this device overhead.
3
www.event-lighting.com.au