Safety Instructions; Power Input & Power Linking; Fuse Replacement - Event Lighting SURF640 User Manual

Safety Instructions

Warning
Do not open this device, there are no user-serviceable parts inside. Risk of electric
•
shock.
• Do not look at the light source when the device is on.
Caution: This unit's housing may be hot during and after operation.
Install this device in a location with adequate ventilation, at least 20 inch (50 cm) from
•
adjacent surfaces.
• Do not leave any flammable material within 50 cm of this unit while operating or
connected to power.
• Use a safety chain when mounting this device overhead.
Do not operate this device outdoors or in any location where dust, excessive heat, water,
•
or humidity may affect it.
• Do not operate this device if the housing, lenses, or cables appear damaged.
Do not connect this device to a dimmer or rheostat.
•
• ONLY connect this device to a grounded and protected circuit.
ONLY use the hanging bracket to carry this device.
•
• In case of a serious operating problem, stop using immediately.
The maximum ambient temperature is 104° F (40° C). Do not operate this device at
•
higher temperatures.
Power Input & Power Linking
This device has an auto-switching power supply work with input voltage range of 100~240 VAC,
50/60 Hz.
Link up to the maximum 8A. DO NOT exceed this.

Fuse Replacement

If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Unscrew the fuse holder on the rear panel with a fitting screwdriver from the housing
(anticlockwise).
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing and fix it.
2
www.event-lighting.com.au