Basic Safety Measures - NT-MDT NTEGRA Therma Instruction Manual

2. Basic Safety Measures

General Safety Measures
- Ground the instrument before operation!
- Do not disassemble any part of the device. Disassembling of the product is permitted
only to persons certified by NT-MDT.
- Do not connect additional devices to the instrument without prior advice from an
authorized person from NT-MDT.
- This instrument contains precision electro-mechanical parts. Therefore protect it from
mechanical shocks.
- Protect the instrument against the influence of extreme temperature and moisture.
- For transport, provide proper packaging for the instrument so as to avoid its damage.
Electronics
- Before operation, set the power switch of the SPM controller to the position
corresponding to value of the local electrical power line (this is only done with the
controller being off!).
- Switch the SPM controller off before connecting/disconnecting its cable connectors.
Disconnecting or connecting the cable connectors during operations may cause damage
to the electronic circuit and disable the instrument. A warning label is attached to the
SPM controller of the instrument (Fig. 2-1).
Chapter 2. Basic Safety Measures
Fig. 2-1
13