Inserting A Compact Flash Memory Card - Avaya G450 Installing

4. Replace the G430 in the rack or mount on the wall, if applicable.
5. Reconnect all cables (data and power) that you disconnected from the G430 and its media
modules, both front and rear
6. Connect the G430 power cable into a mains socket.
7. Use the show platform mainboard CLI command to check the status of the G430 and
its memory module. For example, when the G430 is working properly, sample output
includes:
MAINBOARD BOARD
---------------
Type
Description
Serial Number
HW Vintage
HW Suffix
FW Version
Faults
RAM MEMORY SOCKET #1
--------------------
Type
Serial Number
Manufacture Part Num
Faults
Inserting or removing a compact flash memory card
The G450 and G430 support hot insertion and removal of a compact flash memory card without
power drop, provided the compact flash is not in use when you remove it.

Inserting a compact flash memory card

About this task
Procedure
1. Remove the blank plate covering the compact flash memory card slot, located in the center
of the main board.
2. Position the compact flash memory card so that the vendor name is facing up and the
connector is pointing toward the gateway, and gently insert it into the compact flash slot.
3. After installing the compact flash memory card and the additional 256 MB RAM card, the
announcement files are not automatically moved from the internal flash to the compact flash.
To move them:
a. Make sure the gateway is registered to CM.
b. At the CM, set enable CF to y in the change media-gateway screen.
c. In the SAT interface of the CM, enter enable announcement-board.
The announcement files are copied from internal flash to the compact flash, and the
yellow CARD IN USE LED associated with the compact flash lights up.
January 2018
: G430 mainboard
: Avaya Inc., G430 Media Gateway
: 08IS26191011
: 1
: C
: 29.22.50
: No Fault Messages
: 512MB DDR SDRAM memory module
: 0b2c7605
: 64A6M64M8L-A06EWQU
: No Fault Messages
Installing the upgrade memory kit in the G450 and G430 Media Gateway 10