Alpha ESS Storion-SMILE-T10 Installation Manual page 9

INSTALLATION
Figure 15 Mounting Battery
Step 5 Insert the expansion tube into the drilled hole. Pass the expansion screw through the
gasket and lock with a screwdriver, as Figure 15 shows.
Step 6 M4856-S can be stacked with maximum of 4 batteries in each row. To install another
battery repeat Steps 1~5.
Figure 16 Unpacking the High-voltage Control Box
Step 7 Take the HV50056 out of the packaging box. Pull out the top two guide rods and remove
the front panel. Remove the rear bracket from the HV50056, as shown in Figure 16.
13 14
Step 8 Fix the HV50056 rear bracket with flange nuts on the two bracket of the top battery, as
shown in Figure 17.
Step 9 Cover the PE bag on the top battery to block out the dust before drilling.
Please drill holes directly on the wall at the marking positions of the brackets with an impact drill
(bit φ 8.0mm, length 20cm), and the depth each hole is about 7 cm.
Please insert the expansion tube into the drilled hole. Pass the tapping screw through the gasket
and lock with a screwdriver, as Figure 18 shows.
Figure 17 Placing the Rear Bracket of HV50056
Figure 18 Installation of the Rear Bracket of HV50056
INSTALLATION INSTRUCTIONS