Ems Communication Checking; Assembling Of The Front Panels - Alpha ESS Storion-SMILE-T10 Installation Manual

EMS INTRODUCTION AND SET UP
Figure 60 Date&Time Setting Interface
Step 18 Click System in the setting
menu. Click Date &Time and set up the
date and time.
Note: It is needed to set the following 3 parameters for manual mode:
IP Address: IP address;
Subnet Mask: Subnet mask;
Default Gateway: Default gateway;
Automatic display one parameter:
MAC Address: display MAC Address.
Figure 62 Date&Time Setting Interface
Step 20 Click Language to set language

4.3 EMS Communication Checking

After wiring and EMS setting, check that the status indicators are normal. Then enter
MENU->Status->Communication to check that the communication status of all the
devices are normal.
Figure 61 Ethernet interface
Step 19 Click Ethernet to set the IP
address. DHCP mode means that setup IP
address is set up automatically.
If you want to set up the IP address
manually, please choose manual mode.
Figure 63 Date&Time Setting Interface
Step 21 Make sure all the following
number is correct.
35 36
AC\HYBRID system:
Figure 64 BMS
DC system:
Figure 66 BMS
In an AC/Hybrid mode, the Meter 2 status shows YES, which means normal. In a DC
mode, the Meter 2 status shows YES, which means normal. Then EMS can work
normally.

4.4 Assembling of the Front Panels

Step 18 Inverter part: please unscwer the scwews of Bracket A and hang the front
panel of the inverter onto Bracket B. Fix the front panel to Bracket B with scwews.
Battery and control box: Push the top two guide rods into the housing and press
the buckle from the bottom right in the middle.
EMS INTRODUCTION AND SET UP
Figure 65 Ethernet and Meter
Figure 67 Ethernet and Meter
Figure 68 Assembling of the Front Panels