Alpha ESS Storion-SMILE-T10 Installation Manual page 11

INSTALLATION
Step 5 Before wiring please remove the front maintenance baffle of the batteries with
an across screwdriver.
Figure 21 Installation of the HV50056 and the Inverter
Battery power cable connection sequence:
Through the waterproof cap→through the sealing ring→through the joint, fixed to the
copper bar with M5 nut inside of the battery.
Figure 24 Power Cable Plug Connectors
HV50056 & Battery power cable connection sequence: one side terminal shall go
through the waterproof cap→through the sealing ring→through the joint of the
battery, then be fixed to the copper bar with M5 nut inside of the battery; The plug
connector on the other side shall be connected to the plug port of the HV50056 with
the corresponding color. When a click sound is heard, the connection is correct.
Figure 25 Connection of Communication Cables on Battery Side
17
Terminal Resistance
18
Step 7 Please connect the communication cables as referred in Figure 25
Figure 26 Communication Cables
Battery communication cable connection sequence: the RJ45 connector of the
communication cables shall go through the waterproof cap → through the sealing ring
→through the joint and inserted in to the COM port inside of the battery.
HV50056 & Battery communication cable connection sequence: the RJ45
connector on one side shall go through the waterproof connector inserted into the
COM port inside the battery which is nearest to HV900112. The RJ45 connector on the
other side shall go through the waterproof cover inserted into the LMU port inside the
HV50056.
Terminal Resistance: Insert the terminal resistance into the last COM port of the last
battery.
Figure 27 Connection of the Power Cables and AC Auxiliary Cable
INSTALLATION
NOTE:
1. To remove the waterproof connector, it
shall be rotated counterclockwise according
to the installation procedure.
2. Use a screwdriver to remove the mainte-
nance baffle before wiring.
3. The battery has no circuit breaker for
protection. Please be careful, do not short the
positive and negative terminals during
installation.
4. The waterproof sealing ring needs to be
confirmed that it shall be inserted into the
plastic claw ring during installation.