Setting - Alpha ESS Storion-SMILE-T10 Installation Manual

EMS INTRODUCTION AND SET UP
Figure 47 Battery Model Interface
Step 5 Click the Battery Function and
check battery type M4856-S.
Figure 49 CT Meter Option Interface
Step 7 Choose CT Meter. If you use CT,
please enter the relevant CT ratio. If you
don't use CT, please enter the ratio as 1.
Figure 51 Max. Feed in rate Setting
InterfaceInterface
Step 9 Set the Max. Feed in rate value.
Figure 48 SOC Calibration Interface
Step 6 Check SOC Calibration function set
No.
Figure 50 Grid Setting InterfaceInterface
Step 8 Click the Grid Function to set up
relevant parameters about the grid.
Figure 52 System Mode Setting
Interfaceterface
Step 10 Click Function-System Mode to
set system mode: DC, AC, Hybrid.
33 34
Figure 53 Work Mode Setting
Interface
Step 11 Click the mode then set up work
mode.(self-use or force time charge)
Figure 55 Force Charge Start Time

Setting

Step 13 Set the charge start time
FFigure 57 Charging cut SOC Setting
Step 15 Set the charging cut SOC.
EMS INTRODUCTION AND SET UP
Figure 54 Force Charge Setting Interface
Step 11 If you want to use force charge,
set Enable here.
Figure 56 Force Charge End Time Setting
Step 14 Set the charging start time
Figure 58 Discharging cut SOC Setting
Step 16 Set the discharging cut SOC.