GE LOGIQ 500 Service Manual page 40

GE MEDICAL SYSTEMS
REV 0
2–2–5 Unpacking LOGIQ 500
Do not lift the unit by the Keyboard. Equipment damage may result.
The unit weighs approximately 180kg (397 lbs). Be prepared for a sudden shift of weight as the
unit is removed from its base (pallet).
Refer to ILLUSTRATION 2–2 while performing the following procedure.
1. Cut the two PLASTIC BANDs.
2. Lift the CAP up and off.
3. Remove the eight PLASTIC JOINTs from the OUTER SLEEVEs.
4. Remove the OUTER SLEEVEs.
5. Lift the Monitor up by pressing the <UP/DOWN> button located on the Monitor Arm.
6. Remove the MONITOR SLEEVE.
7. Remove the SLOPE.
8. Remove the UPPER and LOWER CUSHIONs.
9. Unlock the brakes by stepping down on the brake pads in front, then carefully roll the LOGIQ 500 rear side first off
the SKID.
10. Remove the Caution Label attached on the CRT Filter and clean the CRT Filter.
Check the shipping container for special instructions. Verify that the container is intact. In some
cases a secondary container may be used. If so, ask the carrier for unpacking instructions.
CAUTION
CAUTION
Note
2–9
LOGIQ 500 SERVICE MANUAL
P9030TA
INSTALLATION