Settings For Connected Equipment - Furuno ENVISION AR-100M Operator's Manual

2.3.9

Settings for connected equipment

For the satellite speed log (GS-100), SATELLITE COMPASS
DIS (FMD-3200/3300), set them as shown below to connect with the AR navigation
system.
Satellite speed log/SATELLITE COMPASS
Set the transmission rate of the GPatt sentence to "200 msec" or below.
Note: If the communication load is high, reduce the transmission rate for other sen-
tences or turn some sentences off to reduce the communication load.
ECDIS
• Set [Output Route Data Setting] to [File and RMB] on the [TCS] tab of the [Common
Installation Setting] menu.
• Check the checkbox for [Output Chart Objects] on the [Basic Setting] tab of the
[Common Installation Setting] menu.
Note: The AR navigation system cannot overlay ENC chart objects despite the set-
ting for the [Output Chart Objects] checkbox, if the ECDIS has C-MAP charts in-
stalled. Uninstall C-MAP charts to use ENC chart objects.
• Select the equipment ID of the ECDIS that outputs the route data, on the ECDIS
menu.
2. INSTALLATION AND INITIAL SETTINGS
TM
ECD001
ECD001
™
(SC series) and EC-
2-17