Table of Contents
Advertisement
2.3.6
How to setup the data source for the TT data
Do as follows to setup the data source for the TT data.
1. Login as a service technician, referring to subsection 2.3.1.
2. Click [Service Setting].
3. Click [Network].
4. Click [Sentence].
5. Click [TT].
For [TTM (NavNet)] or [TTD/TLB/OSD (NavNet)]
6. Check the appropriate radio button.
• [TTM (NavNet)]: FAR-2××7 or FAR-2××8 radar outputs TT data with the TTM
sentence.
• [TTD/TLB/OSD (NavNet)]: FAR-2××7 or FAR-2××8 radar outputs TT data with
the TTD sentence.
• [TTD/TLB/OSD (TAG Block)]: Use the TT data output from FAR-3000 radars.
7. Do as follows according to the radio button that is checked at step 6.
• For [TTM (NavNet)] or [TTD/TLB/OSD (NavNet)]:
Enter the IP address(es) for the radar. Be sure to enter all IP addresses for the
radar to be assigned as the data source.
Note: All octets for each IP address must be entered. The IP address that has
one or more empty strings is invalid.
• For [TTD/TLB/OSD (TAG Block)]:
Check the checkbox(es) for radar SFI (System Function ID). Be sure to check
all checkboxes for the radar to be assigned as the data source.
8. Click the [Commit & Reset] button to apply the settings.
The AR navigation system application is automatically reset.
2. INSTALLATION AND INITIAL SETTINGS
For [TTD/TLB/OSD (TAG Block)]
2-15
Advertisement
Table of Contents
