Drive Wheel Transmission (Mechanical Feed Output); Locking Device - Vaderstad RAPID RDA 400 S Instructions Manual

Rape brush
Before setting the drill for rapeseed, always check the rape brush and clean it if necessary. Check
that the brush spin easily on it's axle. The rape brush must never be greased.
4.3

Drive wheel transmission (mechanical feed output)

Figure 4.8
Remove the chain casing and check the tension in the chain and the condition of the chain. Grease
the chain every 200 ha.
4.4

Locking device

Figure 4.9
Do not lubricate the locking device. Regularly inspect the device for correct operation. The lock-
ing hooks (A) on the rear of the seed hopper should connect with the lugs (B) on the side sections.
Grease the locking device regularly. Use grease on the angled surface of the locking bar and
around where the bar is in contact with the hopper.
Ver.3 29.06.2007
RDA 400-450 S
B
A
71