Lubrication Points - Vaderstad RAPID RDA 400 S Instructions Manual

Maintenance and service
4.7

Lubrication points

Be safety conscious and do not crawl under the drill to lubricate. Lubricate from above, or support
the drill securely on trestles. See "1 Safety regulations" on page 6.
Lubricate regularly as shown below: the disc bearings should be greased until grease appears or
by 2-3 strokes of the grease gun.
The lubrication chart with picture references can be found in the Spare Parts list.
Table 4.1 Lubrication points and intervals
Lubrication points
Bout markers
Drive wheel chain (mechanical feed output)
Drive wheel suspension (mechanical feed output)
Hinges on centre and side sections, wheel beam pivot X
Parallel linkage
Lifting ram head
Disc bearing
Wheel hub
Wheel fork
Transmission chain (hydraulic feed output)
Oil filter replacement (hydraulic feed output)
Intermediate packer (option)
Wing packer (option)
Grease into all grease nipples at the intervals specified and always after pressure washing the drill.
Never direct water onto a bearing. It is easy to spoil seals and ball bearings with a pressure washer
since water can be forced into the bearing and cause rusting.
Lubricate at the end of each season.
74
Lubrication intervals
100 ha 500 ha/
season
X
X
X
X
X
X
X
X
X
X
X
X
Qty
400/450
6
2
2
4
6
1
32 / 36
16 / 18
16 / 18
1
1
Ver.3 29.06.2007