Vaderstad RAPID RDA 400 S Instructions Manual page 44

Instructions and settings
Low-lift/Full lift
Use push-button
button show which function has been engaged. Use low-lift when drilling. This prevents the ma-
chine from being raised too much, while allowing proper operation of the following harrow in the
headland. Never reverse the machine in the low-lift position.
If it becomes necessary to raise the machine, e.g., when encountering an obstruction in the furrow
or to turn back and fill the seed hopper, be sure to first press
feature. Then press
height.
When the drill later is returned to the same position as before the interruption, press
engage auto advance of tramlining and bout marker switching, and press
lift operation.
The indicator lamp on the left of the button blinks when the low-lift switch has been engaged.
Lift stop
Use the lift stop when the bout markers should be retracted without lifting the machine from the
furrow, e.g., to pass a post or well. Press the button
draulic lever. Use
function that was engaged prior to activating the lift stop.
Tramlining
The selected tramlining programme is shown at the lower left of the display, while the current fur-
row in the sequence is shown at the lower right part.
Keep the button
selection dial to set the desired tramline interval (1 - 20) and confirm with
desired start value using
Tramlining programmes 21 - 30 are special programmes used for lateral tramlining. See "2.21.8
Tramline options" on page 52.
Tramlining programme 31 is used to enter a user-defined tramlining programme.
Keep the
gramme 31 using the dial and confirm with
sired number of sequences in the tramlining cycle. Then use the right part of the display to select
in which sequences tracks should be made and whether they should be on the left and/or right. Ad-
vance to the desired start value using
44
to switch between low-lift and full lift. The indicator lamps next to the
to switch to full lift. The machine can now be raised to its maximum
to alternate between low-lift and full lift. The control box remembers the
depressed until the tramlining programme digit is selected. Then use the
. The lamps (6) light when tramlining is in progress.
button depressed until the tramlining programme number is marked. Select pro-
to disengage the auto advance
and lift the bout marker using the hy-
. In the left part of the menu, first select the de-
.
to re-
to return to low-
. Advance to the
Ver.3 29.06.2007