Nsw Access And Login - ZyXEL Communications NSW Series User Manual

10.2 NSW Ac c e ss a nd L o g in
I forgot the IP address for the NSW.
The default IP address is
1
Use the NCC, the ZON utility, or the console port to find the IP address.
2
If you're using the console port, use the command line "show ip" to find the IP address.
3
I forgot the username and/or password.
The default username is
1
registered with the NCC or
If this does not work, you have to reset the device to its factory defaults. See
2
I cannot see or access the
Make sure you are using the correct IP address.
1
• The default IP address is
• If you changed the IP address, use the new IP address.
• If you changed the IP address and have forgotten it, see the troubleshooting suggestions for
forgot the IP address for the NSW.
Check the hardware connections, and make sure the LEDs are behaving as expected. See
2
on page 22.
Make sure your Internet browser does not block pop-up windows and has JavaScripts and Java
3
enabled.
Make sure your computer is in the same subnet as the NSW. (If you know that there are routers between
4
your computer and the NSW, skip this step.)
Reset the device to its factory defaults, and try to access the NSW with the default IP address. See
5
Section 4.6 on page
If the problem continues, contact the vendor.
6
I can see the
L o g in
Chapter 10 Troubleshooting
http:/ / DHC P- a ssig ne d IP
and the default password is
a dm in
.
1234
screen in the web configurator.
L o g in
http://DHCP-assigned
28.
screen, but I cannot log in to the NSW.
NSW Series User's Guide
.
a ssig ne d b y the NC C
IP.
61
when the NSW is
Section 4.6 on page 28.
I
Section 3.3