Status; C Ha Pte R 5 Sta Tus - ZyXEL Communications NSW Series User Manual

5.1 Sta tus
The screen displays when you log into the NSW or click
Sta tus
configurator. The

Status

Fig ure 29
The following table describes the labels in this screen.
Table 5 Status
L ABEL
Device Information
Device Type
Registered

Status

Boot Version
System Name
Firmware
Version
System Location
Serial Number
screen displays general device information, system status, and its IP addresses.
Sta tus
DESC RIPT IO N
This field displays the model name of the NSW.
This field displays
Re g iste re d
when it is not. You can register the NSW in Nebula Control Center (preferable) or
Unre g iste re d
myZyxel.com. If you register the NSW in myZyxel.com but didn't create an organization in Nebula
Control Center yet, then you will need to register the NSW in Nebula Control Center again. An
unregistered NSW cannot be managed by Nebula Control Center.
This field displays the version number and date of the boot module that is currently on the NSW.
This field displays the name used to identify the NSW on any network.
This field displays the version number and date of the firmware the NSW is currently running.
This field displays the location configured for the NSW in the Nebula Control Center.
This field displays the serial number of the NSW. The serial number is used for device tracking and
control.
NSW Series User's Guide
C
Sta tus
when the NSW is registered with the Nebula Control Center and
30
HA PTER
Sta tus
at the top right corner of the web
5