Ip Setup For Nsw200-28P; Management Ip Address - ZyXEL Communications NSW Series User Manual

Basic Setting > IP Setup (NSW100 Series)
Fig ure 31
The following table describes the labels in this screen.
Table 7 Basic Setting > IP Setup (NSW100 Series)
L ABEL
Default Management IP Address
DHCP Client
Static IP
Address
IP Address
IP Subnet
Mask
Default
Gateway
Static
Domain
Name Server
Preference 1-
2
VID
Apply
Cancel
6.4 IP Se tup fo r NSW200- 28P
6.4.1 Ma na g e m e nt IP Addre ss
The NSW needs an IP address for it to be managed over the network. The factory default IP address is
. If there is not a DHCP server to assign the NSW an IP address, then you must give the NSW a
DHC P C lie nt
static IP address. The subnet mask specifies the network number portion of an IP address.
Chapter 6 Basic Setting
DESC RIPT IO N
Select this option if there is a DHCP server that can assign the NSW an IP address, subnet mask,
a default gateway IP address and a domain name server IP address automatically.
Select this option if you don't have a DHCP server or if you wish to assign static IP address
information to the NSW. You need to fill in the following fields when you select this option.
Enter the IP address of your NSW in dotted decimal notation.
Enter the IP subnet mask in dotted decimal notation, for example, 255.255.255.0.
Enter the default gateway of the Zyxel device.
You can assign static domain name to its corresponding IP address. You need to fill in the
following fields.
Enter a domain name server IPv4 address in this field. 1 and 2 are the priority of the DNS server
address.
Enter the VLAN identification number.
Click to save your changes to the NSW's run-time memory. The NSW loses these changes
Apply
if it is turned off or loses power, so use the Save link on the top navigation panel to save your
changes to the non-volatile memory when you are done configuring.
Click to reset the fields to your previous configuration.
C a nc e l
NSW Series User's Guide
35