Table 18 Advanced Application > VLAN > VLAN Configuration> VLAN Port Setup
L ABEL
DESC RIPT IO N
VLAN Trunking
Enable
connected to end users) to allow frames belonging to unknown VLAN groups to pass through
the NSW.
Apply
Click
changes if it is turned off or loses power, so use the
save your changes to the non-volatile memory when you are done configuring.
Cancel
Click
Chapter 7 VLAN
on ports connected to other switches or routers (but not ports directly
VL AN T runking
to save your changes to the NSW's run-time memory. The NSW loses these
Apply
to begin configuring this screen afresh.
C a nc e l
NSW Series User's Guide
48
link on the top navigation panel to
Sa ve