ZyXEL Communications NSW Series User Manual page 38

Basic Setting > IP Setup > IP Configuration
Fig ure 35
The following table describes the labels in this screen.
Table 11 Basic Setting > IP Setup > IP Configuration
L ABEL DESC RIPT IO N
Default Type the IP address of the default outgoing gateway in dotted decimal notation, for example
Gateway 192.168.1.254.
Apply Click
Apply
if it is turned off or loses power, so use the
changes to the non-volatile memory when you are done configuring.
Cancel Click
C a nc e l
IP Interface
DHCP Client Select this option if you have a DHCP server that can assign the NSW an IP address, subnet
mask, a default gateway IP address and a domain name server IP address automatically.
Static IP Select this option if you don't have a DHCP server or if you wish to assign static IP address
Address
information to the NSW. You need to fill in the following fields when you select this option.
IP Address Enter the IP address of your NSW in dotted decimal notation.
IP Subnet Enter the IP subnet mask in dotted decimal notation, for example, 255.255.255.0.
Mask
VID Enter the VLAN identification number.
Add Click this to create a new entry.
This saves your changes to the NSW's run-time memory. The NSW loses these changes if it is
turned off or loses power, so use the
to the non-volatile memory when you are done configuring.
Cancel Click
C a nc e l
Index This field displays the index number of an entry.
IP Address This field displays IP address of the NSW.
IP Subnet Mask This field displays the subnet mask of the NSW.
VID This field displays the VLAN identification number of the NSW.
Type This field displays the type of IP address status.
Chapter 6 Basic Setting
to save your changes to the NSW's run-time memory. The NSW loses these changes
to reset the fields to your previous configuration.
Sa ve
to reset the fields to your previous configuration.
NSW Series User's Guide
38
link on the top navigation panel to save your
Sa ve
link on the top navigation panel to save your changes