Vlan Configuration; Configure A Static Vlan - ZyXEL Communications NSW Series User Manual

7.3 VL AN C o nfig ura tio n
Use this screen to view IEEE 802.1Q VLAN parameters for the NSW. Click
VL AN C o nfig ura tio n
Advanced Application > VLAN > VLAN Configuration
Fig ure 40
The following table describes the labels in the above screen.
Table 16 Advanced Application > VLAN > VLAN Configuration
L ABEL
Static VLAN Setup
VLAN Port Setup
7.4 C o nfig ure a Sta tic VL AN
Use a static VLAN to decide whether an incoming frame on a port should be
• sent to a VLAN group as normal depending on its VLAN tag.
• sent to a group whether it has a VLAN tag or not.
• blocked from a VLAN group regardless of its VLAN tag.
You can also tag all outgoing frames (that were previously untagged) from a port with the specified
VID.
Use this screen to configure a static VLAN for the NSW. Click the
C o nfig ura tio n
Chapter 7 VLAN
to see the following screen.
DESC RIPT IO N
Click
C lic k He re
Click
C lic k He re
screen to display the screen as shown next.
NSW Series User's Guide
to configure the Static VLAN for the NSW.
to configure the VLAN Port for the NSW.
Sta tic VL AN Se tup
44
>
Adva nc e d Applic a tio n
link in the
VL AN
>
VL AN