Ftp Command Line Procedure - ZyXEL Communications NSW Series User Manual

8.7.2.1 Exa m ple FT P C o m m a nds
ftp> put firmware.bin ras
This is a sample FTP session showing the transfer of the computer file "firmware.bin" to the NSW.
ftp> get config config.cfg
This is a sample FTP session saving the current configuration to a file called "config.cfg" on your
computer.
If your (T)FTP client does not allow you to have a destination filename different than the source, you will
need to rename them as the NSW only recognizes "config" and "ras". Be sure you keep unaltered
copies of both files for later use.
Be sure to uplo a d the c o rre c t m o de l firm wa re a s uplo a ding the wro ng
m o de l firm wa re m a y da m a g e yo ur de vic e .
8.7.3 FT P C o m m a nd L ine Pro c e dure
Launch the FTP client on your computer.
1
Enter open, followed by a space and the IP address of your NSW.
2
Press [ENTER] when prompted for a username.
3
Enter your password as requested (the default is "assigned by the NCC" when the NSW is registered with
4
the NCC or "1234").
Enter bin to set transfer mode to binary.
5
Use put to transfer files from the computer to the NSW, for example, put firmware.bin ras transfers
6
the firmware on your computer (firmware.bin) to the NSW and renames it to "ras". Similarly, put
config.cfg config transfers the configuration file on your computer (config.cfg) to the NSW and
renames it to "config". Likewise get config config.cfg transfers the configuration file on the NSW to
your computer and renames it to "config.cfg". See
filename conventions.
Enter quit to exit the ftp prompt.
7
Chapter 8 Maintenance
Table 22 on page 55
NSW Series User's Guide
56
for more information on