Advantech ADAM-5511 Manual page 52

Port Select:
Dip
ON Com1 Enable
OFF Com1 Disable
DIP switches 7 and 8 are for baud rate settings.
Baud Rate:
Dip 7 Dip 8
OFF
ON
OFF
ON
This section provides basic information on wiring the power supply, I/
O units, communication port connections and programming port
connection.
Power supply wiring
Although the ADAM-5511 systems are designed for a standard
industrial unregulated 24 V
unit that supplies within the range of +10 to +30 V
supply ripple must be limited to 200 mV peak-to-peak, and the immedi-
ate ripple voltage should be maintained between +10 and +30 V
Screw terminals +Vs and GND are for power supply wiring.
Note: The wires used should be at least 2 mm in size.
6
Baud Rate
OFF 9600
OFF 19200
ON 38400
ON 115200
power supply, they accept any power
DC
. The power
DC
.
DC