Advantech ADAM-5511 Manual page 25

Note: Before setup ADAM-5511 system, user need to config-
ure the I/O module first, and ADAM-4000/5000 Utility
Software provides a graphical user interface for config-
uring and calibrating Advantech ADAM-4000/5000
Modules.
4. Module Configuration:
Sets the input/output range, baud rate, data format, checksum status.
Note: Baud rate and Checksum can only be changed in the
INIT* state. Changed settings only take effect after a
module is rebooted.
Address: Represents the address of the module. Range is from 0 to
255.
Baudrate: Represents the baud rate.
Checksum: Represents the checksum status, i.e., disabled/enabled.
Firmware Ver: Represents the module's firmware.
Input range: Represents the type. Please refer to the module user's
manual.
Data format: Represents the data format. Please refer to the module
user's manual.