Advantech ADAM-5511 Manual page 23

• One RS-232 DB-9 crossover cable for COM1 use.
• One straight through DB-9 cable for COM3 use
1. Make sure that everything described in Section 0.1 is ready.
2. Set all the DIP switches off on ADAM-5511 back plant. See Figure
0-1.
3. Connect the ADAM-5511 power cable between the power supply
and the ADAM-5511 screw terminals (+Vs and GND). Please make
sure that the power source is between +10 to +30 VDC .
4. Connect the straight through cable between the host computer and
the ADAM-5511 COM3 for I/O modules configuration.