Maintenance And Cleaning; Cleaning The Vision Screener - Welch Allyn Spot VS100 Directions For Use Manual

Maintenance and cleaning

Cleaning the vision screener

If liquids are spilled on the vision screener:
1. Turn off the vision screener.
2. Disconnect the power plug.
3. Dry off excess liquid from the vision screener.
If liquids possibly entered the vision screener, remove the vision screener from use until
it has been properly dried, inspected, and tested by qualified service personnel.
Clean on a routine basis according to your facility's protocols and standards or local
regulations.
The following agents are compatible with the vision screener:
• 70 percent isopropyl alcohol
• 10 percent chlorine bleach solution
Note
Cleaning with 70 percent isopropyl alcohol
Wipe the vision screener with a clean cloth slightly dampened with 70 percent
isopropyl alcohol.
Cleaning with 10 percent chlorine bleach solution
1. Wipe the vision screener with a clean cloth slightly dampened with a 10 percent
bleach and water solution. Follow the cleaning agent manufacturer's guidelines.
2. Rinse with a clean cloth slightly dampened with water that meets EP and USP
quality standards.
WARNING Electric shock hazard. Before cleaning the vision screener,
disconnect the DC power cord from the power outlet and the vision
screener.
WARNING Liquids can damage electronics inside the vision screener.
Prevent liquids from spilling on the vision screener.
Disinfect according to your facility's protocols and standards or local
regulations.
37