Static Mode; Dmx Configuration; Dmx Mode - ProLights MINICLIPSEWD User Manual

12

3.5 STATIC MODE

This fixture has the ability to accept custom static color settings. Access this via the control panel.
• To enable the static mode, press MENU repeatedly until STATIC shows on the display.
• Through the button UP/DOWN select DIMMER or STROBE then press the button ENTER.
• Set the value (000 - 255), through the buttons UP/DOWN.
• Press the button ENTER to confirm.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.

3.6 DMX CONFIGURATION

MINIECLIPSEWD/TRWD is equipped with different DMX configuration.
• Press the button MENU so many times until shows DMX CHANNEL, and press the button ENTER to confirm.
• Select the desired DMX configuration (1CH - 2CH - 5CH ) through the buttons UP/DOWN.
The tables on page 13 indicate the operating mode and DMX value.

3.7 DMX MODE

• Press the button MENU so many times until the display shows DMX ADDRESS, and press the button ENTER
to confirm.
• Press UP/DOWN button to select the desired value (001-512). Press and hold to scroll quickly.
• Press ENTER button to store.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.
To able to operate the MINIECLIPSEWD/TRWD with a light controller, adjust the DMX start address for the
first a DMX channel. If e. g. address 33 on the controller is provided for controlling the function of the first
DMX channel, adjust the start address 33 on the MINIECLIPSEWD/TRWD. The other functions of the light
effect panel are then automatically assigned to the following addresses.
An example with the start address 33 is shown below:
Number of
Start address
DMX
(example)
channels
5 33
MINIECLIPSEWD - MINIECLIPSETRWD
DMX Address Next possible start
occupied address for unit No. 1
33-37
DMX512 Controller
Next possible start
address for unit No. 2
38
wireless
solution
Fig.6 - Esempio di configurazione a 7 canali DMX
Next possible start
address for unit No. 3
43 48