Menu Structure; Autoshow Mode - ProLights MINICLIPSEWD User Manual

MINIECLIPSEWD - MINIECLIPSETRWD

3.3 MENU STRUCTURE

MENU (LEVEL 1)
1 Auto Show
2 Static
3 Dimmer Mode
4 Back Light
5 Information
6 DMX Address
7 DMX Channel
8 Master/Slave
9 Wireless Setting
3.4 AUTO SHOW MODE
If no DMX control signal is present at the DMX INPUT, the unit independently runs through its show pro-
gramme provided that the blackout mode is switched off:
• Press the button MENU so many times until the display shows AUTO, then press the button ENTER.
• Press the button UP/DOWN to switch between the show AUTO 1 - AUTO 4. The unit will operate in show
mode.
• Using the button UP/DOWN to select the desired run speed slow-fast (0-100)
• Press the button ENTER to save the setting.
IMPORTANT: Programs AUTO 1 - AUTO 4 are fully pre-programmed and will not be altered by changes.
NOTE - To deactivate AUTOSHOW mode, activate SLAVE function.
(LEVEL 2)
Auto Show Speed
< Auto 1 >
< Auto 2 >
< Auto 3 >
< Auto 4 >
Dimmer
Strobe
< Off >
<Dimmer1>
<Dimmer2>
<Dimmer3>
< On >
< 10 s >
< 20 s >
< 30 s >
Fixture Hours
Version
< 001 >
< 1 Ch >
< 2 Ch >
< 5 Ch >
Master
Slave
Receive Setting
Receive Reset
(LEVEL 3)
< 100 > Default: Auto 1; Speed:100
< 100 >
< 100 >
< 100 >
255 Default: 255
0 Default: 0
Off: Dimmer speed On/Off
DIM 1: Dimmer speed fast 0.8 s
DIM 2: Dimmer speed middle 1.6 s
DIM 3: Dimmer speed slow 2.4 s
Default: On
10 s: Off after 10 seconds
20 s: Off after 20 seconds
30 s: Off after 30 seconds
< 9999H>
< V1.0 >
Default 001
Default 5CH
Default: Slave
< On > Default: Off
< Off>
< No >
< Yes >
11
REMARK