Fixture Settings; Fixture Informations; Wireless Setting - ProLights MINICLIPSEWD User Manual

14

3.9 FIXTURE SETTINGS

It is possible to change the parameter value in the following way:
Dimmer
• Enter in Dimmer mode to select specific dimming curve, press the button MENU so many times
until shows DIM MODE, and press the button ENTER to confirm.
• Press the button UP/DOWN to select OFF - DIM1 - DIM2 - DIM3.
• Press ENTER button to store.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.
Back Light
• To activate Backlight display press the button MENU so many times until shows BACK LIGHT, and press
the button ENTER to confirm.
• Press the button UP/DOWN to select ON - 10S - 20S - 30S.
• Press ENTER button to confirm the selection.
• Press the MENU button to go back or to meet the waiting time to exit from the setup menu auto-
matically.
3.10 FIXTURE INFORMATION
Fixture Hours
Show the fixture working hours.
• Press the button MENU so many times until shows INFORMATION. Press the button ENTER to confirm
• Using the button UP/DOWN to select FIX HOURS, then press the button ENTER to confirm
• Then the display will show the working hours.
• Press the MENU button to go back or to meet the waiting time to exit from the setup menu auto-
matically
Version
Show the fixture firmware version.
• Press the button MENU so many times until shows INFORMATION
• Select through the button UP/DOWN the VERSION menu voice.
• The display will show the firmware data.
• Press the MENU button to go back or to meet the waiting time to exit from the setup menu automatically.

3.11 WIRELESS SETTING

To set the wireless mode refer to the following guide:
• Press the MENU button until the display shows Wireless Setting, then press the ENTER button.
• Use the UP/DOWN button until the display reads Wireless Receive, and then press the ENTER button
and select the ON mode.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.
NOTE - After you complete these steps, you have to synchronize with any wifi unit with which you
want to communicate by pressing the sync button present on the same. Then connect any DMX
console to wifi unit for to open the communication with the MINIECLIPSEWD/TRWD unit.
• To reset the unit press the MENU button until the display shows Wireless Reset, then press the ENTER
button.
• Use the UP/DOWN button until the display reads Yes, and then press the ENTER button.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.
MINIECLIPSEWD - MINIECLIPSETRWD