Auto Show Mode; Static Mode; Master/Slave Mode; Linking - ProLights ECLIPSETU User Manual

12
10 LED Frequency
11 Temperature

3.4 AUTO SHOW MODE

If no DMX control signal is present at the DMX INPUT, the unit independently runs through its show pro-
gramme provided that the blackout mode is switched off:
• Press the button MENU so many times until the display shows AUTO, then press the button ENTER.
• Press the button UP/DOWN to switch between the show AUTO 0 - AUTO 3. The unit will operate in show
mode.
• Using the button UP/DOWN to select the desired run speed slow-fast (0-100)
• Press the button ENTER to save the setting.
IMPORTANT: Programs AUTO 0 - AUTO 3 are fully pre-programmed and will not be altered by changes.

3.5 STATIC MODE

This fixture has the ability to accept custom static color settings. Access this via the control panel.
• To enable the static mode, press MENU repeatedly until STATIC shows on the display.
• Through the button UP/DOWN select DIMMER or STROBE then press the button ENTER.
• Set the value (000 - 255), through the buttons UP/DOWN.
• Press the button ENTER to confirm.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.

3.6 MASTER/SLAVE MODE

This mode will allow you to link up the units together without a controller. Choose a unit to function as the
Master. The unit must be the first unit in line; other units will work as slave with the same effect.
• Press the button MENU so many times until the display shows MASTER/SLAVE and press the button ENTER.
• Press UP/DOWN to set the unit as master or slave (MASTER, SLAVE).
• Use standard DMX cables to daisy chain your units together via the DMX connector on the rear of the
units. For longer cable runs we suggest a terminator at the last fixture (see page 14).

3.7 LINKING

Several units may be interconnected in order to control all further slave units to the same effect of the
master unit.
1. Connect the DMX OUT of the master unit via 5-pole XLR cable to the DMX IN of the first slave unit.
2. Connect the DMX OUT of the first slave unit to the DMX IN of the second slave unit, etc. until all units
are connected in a chain.
LED Frequency
< 1200 Hz >
< 33 C >
ECLIPSE
< 600 Hz >
< 1200 Hz >
< 2000 Hz >
< 4000 Hz >
< 25 kHz >
Default: 1200 Hz