Static Mode; Manual Mode; Slave Receive Mode; Operations In Automatic Mode - ProLights Eclipse FC User Manual

3.4 STATIC MODE

This fixture has the ability to accept custom static color settings. Access these chases via the control panel
on the back of the fixture.
• Press the button MODE so many times until the display shows STATIC, then press the button ENTER.
• Select Presets through the buttons UP/DOWN, then press the button ENTER.
• Set the colors All, Red, Green, Blue, Lime, Cyan, Magenta, Yellow, Orange, Light Yellow, Light Blue, Light Pink, White
2700K, White 3200K, White 4200K, White 5000K, White 5500K, White 6000K, White 7000K, White 8000K, White 9000K,
White 10000K, through the buttons UP/DOWN, then press the button ENTER.
• Press the MODE button to go back or to meet the waiting time to exit the setup menu.

3.5 MANUAL MODE

This mode allows to combine the colors red, green, blue and lime.
• Press the button MODE so many times until the display shows STATIC, then press the button ENTER.
• Select Color Mix through the buttons UP/DOWN, then press the button ENTER.
• Select the color Red, Green, Blue, Lime through the buttons UP/DOWN, then press the button ENTER.
• Using UP/DOWN button, select the desired color value 000 - 255.
• Press ENTER button to continue to the next color Red, Green, Blue, Lime.
• Continue until the desired mix is obtained.
• Press the MODE button to go back or to meet the waiting time to exit the setup menu.

3.6 SLAVE RECEIVE MODE

This mode will allow you to link up the units together without a controller. Choose a unit to function as the
Master. The unit must be the first unit in line; other units will work as slave with the same effect.
• Press the button MODE so many times until the display shows STATIC, then press the button ENTER.
• Select Play through the buttons UP/DOWN, then press the button ENTER.
• Select Slave receive, then Master/Slave.
• Press UP/DOWN to set the unit as master or slave (Master, Slave).
Use standard DMX cables to daisy chain your units together via the DMX connector on the rear of the
units. For longer cable runs we suggest a terminator at the last fixture (see page 14).

3.7 OPERATIONS IN AUTOMATIC MODE

The unit independently runs through its show.
• Press the button MODE so many times until the display shows STATIC, then press the button ENTER.
• Select Play through the buttons UP/DOWN, then press the button ENTER. Select Presets (if selected, the
fixture will power on with the latest preset or mixed color).
• Press the MODE button to go back or to meet the waiting time to exit the setup menu.

3.8 LINKING

1. Connect the DMX OUT of the master unit via 5-pole XLR cable to the DMX IN of the first slave unit.
2. Connect the DMX OUT of the first slave unit to the DMX IN of the second slave unit, etc. until all units
are connected in a chain.

3.9 DMX CONFIGURATION

ECLIPSEFS is equipped with different DMX configuration.
• Press the button MODE so many times until shows CONNECT, and press the button ENTER to confirm.
ECLIPSEFS
11