Auto Show Mode; Static Mode; Master/Slave Mode - ProLights LUMIPAR7VWPRO User Manual

8 M & S
< Master >
9 White

3.4 AUTO SHOW MODE

If no DMX control signal is present at the DMX INPUT, the unit independently runs through its show pro-
gramme provided that the blackout mode is switched off:
• Press the button MENU so many times until the display shows [AUTO], then press the button ENTER.
• Press the button UP/DOWN to switch between the show (AUTO 1 - AUTO 5). The unit will operate in show
mode.
• Using the button UP/DOWN to select the desired run speed slow-fast [0-100]
• Press the button ENTER to save the setting.
IMPORTANT: Programs AUTO 1 - AUTO 5 are fully pre-programmed and will not be altered by changes. Instead,
MANU C mode allows to combine WarmWhite [W] and ColdWhite [C].
• Press the button MENU so many times until the display shows [STATIC], then press the button ENTER.
• Through the button UP/DOWN select [MANU C], then press the button ENTER.
• Select the color WarmWhite [W] and ColdWhite [C] through the buttons UP/DOWN.
• Press the button ENTER to confirm.
• Set the value (000 - 255), through the buttons UP/DOWN.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.

3.5 STATIC MODE

The fixture has preprogrammed, static looks that may be triggered without a controller [W-C-CW]. Access
these chases via the control panel on the back of the fixture.
• To enable the static mode, press MENU repeatedly until [STATIC] shows on the display.
• Through the button UP/DOWN select [FIXT C].
• Press ENTER button to confirm.
Select the desired preset color using the button UP/DOWN and press ENTER to confirm.

3.6 MASTER/SLAVE MODE

This mode will allow you to link up the units together without a controller. Choose a unit to function as the
Master. The unit must be the first unit in line; other units will work as slave with the same effect.
• Press the button MENU so many times until the display shows [M & S] and press the button ENTER.
• Press UP/DOWN to set the unit as master or slave (MASTER, SLAVE).
• Use standard DMX cables to daisy chain your units together via the DMX connector on the rear of the
units. For longer cable runs we suggest a terminator at the last fixture (see page 11).
LUMIPAR7VWPRO
Mode M & S
Balance
Balance < W = 255 >
< C = 255 >
Mode
< Master >
< Slave >
Value
< W = 255 >
< C = 255 >
9